| Mileage Correction .Net :: |
| Author |
Message |
stephane
Guest
|
| Posted: Fri Nov 25, 2005 2:30 am Post subject: fiat punto |
 |
|
hello
i'have try to program it with 3 points solder
but nothing someone can help me please
the dash was made the 20/03/2000
it's not the same in the manual but i have solder the 3 point
but i can't know the good version
please help me |
|
| Back to top |
|
 |
Google
|
| Posted: Post subject: Sponsored Link |
|
|
|
|
| Back to top |
|
|
Nick
Moderator
Joined: 24 Oct 2005
Posts: 623
|
| Posted: Sat Nov 26, 2005 11:52 am Post subject: program fiat punto |
|
|
Hello Stephane,
only if you read the original mileage you can program it.
Maybe itīs a new dash and there is an eeprom???
Regards,
Nick |
|
| Back to top |
|
|
momo
Junior member
Joined: 09 Jun 2005
Posts: 17
Location: france
|
| Posted: Sun Nov 27, 2005 1:35 am Post subject: fiat punto |
|
|
hello
i'm sure it's not an eeprom it's processor hc08
the car it's an 2000
but the manual diga tell solder only three point
but i don't know if it's the same sens 1.2.3 or 1.3.2or 3.2.1etc
please help me
thanks |
|
| Back to top |
|
|
macshade
Junior member
Joined: 29 Sep 2004
Posts: 21
|
| Posted: Thu Feb 23, 2006 8:25 pm Post subject: Fiat Punto 2000 |
|
|
| I have the same problem, doing by can apper's ????? so i didn't program, but by 3 point soldering the diga stays in working in all version except 2000 V3, but in 2000 V3 it says wrong checksum!!! I simply cannot program this. Can you help me? |
|
| Back to top |
|
|
michel
Junior member
Joined: 20 May 2005
Posts: 16
|
| Posted: Fri Feb 24, 2006 6:46 pm Post subject: Putno problem |
|
|
I have absolutely same problems. I have made 3 Punto dasboards year 2000-2001 and all was not able to change. Only with CAN dongle and rear cluster connector, but only km UP!!! I think Diga have little (BIG  )) problem on it. Same as Skoda Fabia over OBD. |
|
| Back to top |
|
|
macshade
Junior member
Joined: 29 Sep 2004
Posts: 21
|
| Posted: Fri Feb 24, 2006 7:10 pm Post subject: punto |
|
|
| I tested in two car's same result, it simply doesen't work. i tried by can but i didn't suceed.... when it read's it show's ????? if i program the cluster goes to error.... then i have to program it with year 2000 version 3 it work's but stays in 0 KM. But i need to put correct KM and didn't succedd. |
|
| Back to top |
|
|
|
