| Mileage Correction .Net :: |
| Author |
Message |
Ricky
Member
Joined: 25 Mar 2008
Posts: 33
|
| Posted: Tue May 20, 2008 7:12 am Post subject: help |
 |
|
| hi guys, can I use the diga programmer on 24 volt chip. I mean I want to adjust the mileage on a isuzu pick up. It's 24 volts |
|
| Back to top |
|
 |
Google
|
| Posted: Post subject: Sponsored Link |
|
|
|
|
| Back to top |
|
|
hcip
Senior Member
Joined: 03 Mar 2006
Posts: 190
Location: Brgy. Commonwealth, Quezon City Philippines
|
| Posted: Tue May 20, 2008 2:32 pm Post subject: |
|
|
Even The dash has an external voltage of 24volts
inside has a circuit called voltage regulator to reduce the voltage and supply the IC
most eeprom programable has a voltage from 3.3 volt to 5V
Some flash IC has a programming voltage up to 12 volts
I never heard yet the programable chip that has a programming voltage up to 24 volts
therefore you can used Diga to program it
remove the chip and clip the eeprom if the eeprom number is supported by diga
You can used diga as eeprom programmer if you have a knowledge
in hex files and editing datasheet
regards |
|
| Back to top |
|
|
speedo35
Junior member
Joined: 20 May 2008
Posts: 13
|
| Posted: Wed Jun 04, 2008 3:19 pm Post subject: Re: help |
|
|
| Ricky wrote: | | hi guys, can I use the diga programmer on 24 volt chip. I mean I want to adjust the mileage on a isuzu pick up. It's 24 volts |
Yes i done a 2008 model, Diga does support, you must do it under Isuzu -2003 and you need to take chip off |
|
| Back to top |
|
|
|
