| Mileage Correction .Net :: |
| Author |
Message |
Guest
|
| Posted: Sat Mar 01, 2008 11:46 am Post subject: Land Rover 1996 |
 |
|
Hi,
I need someones help...I changed the miles on the board (M28C16), but now it says that the miles are not correct.
Can anyone tell me if it stays memorized on any other control unity, and if it has an eprom or a cpu??
Many thanks, |
|
| Back to top |
|
 |
Google
|
| Posted: Post subject: Sponsored Link |
|
|
|
|
| Back to top |
|
|
hcip
Senior Member
Joined: 03 Mar 2006
Posts: 146
Location: Brgy. Commonwealth, Quezon City Philippines
|
| Posted: Sat Mar 01, 2008 4:08 pm Post subject: |
|
|
Hello
Remove the Device M28C16 from the dash and all the bulb,
put back the dash in the car withouth the M28C16 and start the car
for about 3 sec to reset the other memory then put back the M28c16 in dash it should show the correct mileage
regards |
|
| Back to top |
|
|
4eprom
New member
Joined: 01 Mar 2008
Posts: 1
|
| Posted: Sun Mar 02, 2008 9:39 am Post subject: |
|
|
Hi,
Thanks for youre reply,just to say that the miles that I changed appear correct, but there is a message after a few seconds starting the car(the miles are not correct). Is that what you were refering to when you said that it should show the correct millage???
Thanks |
|
| Back to top |
|
|
hcip
Senior Member
Joined: 03 Mar 2006
Posts: 146
Location: Brgy. Commonwealth, Quezon City Philippines
|
| Posted: Sun Mar 02, 2008 5:22 pm Post subject: |
|
|
| 4eprom wrote: | Hi,
Thanks for youre reply,just to say that the miles that I changed appear correct, but there is a message after a few seconds starting the car(the miles are not correct). Is that what you were refering to when you said that it should show the correct millage???
Thanks |
yes!!!
regards |
|
| Back to top |
|
|
|
